EHEIM pHcontrol+ 6062 Bedienungsanleitung Seite 27

English
Operation
System requirement
WLAN-enabled terminal device (smartphone, tablet, notebook etc.)
Creating the network
1. Insert the switching power supply unit in the mains socket. The status LED ⑨
illuminates (⌦I).
‧ The status LED flashes white: The network is being searched for or created
‧ The status LED illuminates blue: A new network has been created (master mode)
Connecting to the WLAN network
2. Open the network settings of your terminal device (smartphone, tablet, notebook
etc.).
3. Connect the terminal device to the WLAN network (SSID)
EHEIM pHcontrol XXXXXXXX.
4. Enter the network security key.
You can find the security key of the network at the back of the pH controller. Alterna-
tively, you can also scan the QR code 1 (see label) to establish the connection for the
first time (⌦J).
Calling up the website
5. Open your web browser and enter the following address: http://192.168.1.1
Alternatively, you can also scan the QR code 2 (see label) to open the software in the
browser.
Initial configuration
6. Select the desired language from the language selection and follow the instruc-
tions for the initial configuration.
Meaning of the status LED
‧ The status LED flashes white: The network is being searched for or created
‧ The status LED illuminates blue: pH controller is in master mode
‧ The status LED illuminates green: pH controller is connected to another EHEIM digital unit
27