Manoeuvring The Caravan - Truma Mover SX Gebrauchsanweisung

Operation
so that the engagement lever no longer springs back
(Fig. 14-2)�
Fig. 15
To check that the engagement has been successful:
The drive rollers are pressed approx� 20 mm into the
•
tyres on both sides (Fig. 15)�
If the drive units do not engage properly, see
Kapitel 6 Malfunctions�
5.4

Manoeuvring the caravan


WARNING
Personal injury due to a lack of safety
precautions
If persons or objects are present in the mano-
euvring range during the manoeuvring, injuries
may occur�
There must not be any people or objects in
the manoeuvring range�
Nobody may remain in or on the caravan�

CAUTION
Personal injury due to the manoeuvring
system malfunctioning
Malfunctions in the manoeuvring system, the
control unit or the remote control can lead to
the caravan moving unpredictably�
The slide switch on the side for switching off the
remote control can also be used as an emergency
stop function in dangerous situations� If there are
noticeable problems, slide the slide switch on the
side to "OFF"� See Kapitel 4�5�5
Apply the parking brake
Interruption of the battery cut-off switch

NOTICE
Damage to the tyres due to manoeuvring
with the parking brake applied
If the caravan's parking brake is not released af-
ter the engagement, the tyres may be damaged
when the caravan is manoeuvred�
Before manoeuvring, release the parking bra-
ke or remove the chocks�
When the buttons are released, or if the radio signal is
interrupted or becomes too weak, the caravan immedi-
ately stops moving�
Precise movement in all directions is possible using the
control knob and the slide control�
The caravan starts to move without jolting when
starting�
32 EN
When the control knob or slide control are released, or
if the radio signal is interrupted or becomes too weak,
the caravan stops moving immediately�
Radio equipment or other remote controls will not acti-
vate your manoeuvring system�
After start-up, the manoeuvring system moves at a
steady speed (depending on the position of the slide
control)� Speed increases slightly on downhill slopes
and decreases on uphill slopes�
Mover
SX
Control knob only
The caravan symbol on the control knob indicates the
current direction of travel (of the caravan)�
The further the control knob is moved, the faster the ca-
ravan turns on the spot�
Turns on the spot without forward or backward
movement
Fig. 16
Fig. 17
Slide control only
The slide control can be used to drive forwards or back-
wards without jolting, with infinitely variable speed
control�
The further the slide control is moved from the zero po-
sition, the faster the speed�
Caravan moves forwards (towards the drawbar)
Clockwise direction
Anti-clockwise direction
Mover SX
60031-00305 ∙ 00 ∙ 08/2022