Displaying And Deleting Measurements - Beurer BM 45 Gebrauchsanweisung

It is important to consult your doctor regularly for advice. Your
doctor will tell you your individual values for normal blood pres-
sure as well as the value above which your blood pressure is
classified as dangerous.
The classification on the display and the scale on the unit show
which category the recorded blood pressure values fall into. If
the values of systole and diastole fall into two different WHO
categories (e.g. systole in the 'High normal' category and dias-
tole in the 'Normal' category), the graphical WHO classification
on the unit always shows the higher category; for the example
given this would be 'High normal'.

7. Displaying and deleting measurements

The results of every successful measurement are stored
together with the date and time. If there are more than 60
measurements, the oldest measurements are lost.
• To access memory recall mode, the blood pressure
monitor must first be started. To do this press the Start/
stop button .
• Within 3 seconds of the full-screen display appearing,
select the desired user memory (
M2 memory button.
– To view the measurements for user memory , press
the M1 memory button.
– To view the measurements for user memo-
ry , press the M2 memory button.
Your last measurement will appear on the
display.
) with the M1 or
23
• Press the relevant memory button (M1 or M2).
If you have selected user memory1, the M1 memory
button must be pressed.
If you have selected user memory2, the M2 memory
button must be pressed.
A flashes on the display.
The average value of all saved measured
values in this user memory is displayed.
• Press the relevant memory button (M1 or M2).
AM flashes on the display.
The average value of the morning measure-
ments for the last 7 days is displayed (morn-
ing: 5.00 a.m. – 9.00 a.m.).
• Press the relevant memory button (M1 or M2).
PM flashes on the display.
The average value of the evening measure-
ments for the last 7 days is displayed (even-
ing: 6.00 p.m. – 8.00 p.m.).