Measuring Blood Pressure - Beurer BC 20 Gebrauchsanleitung

• The cuff must be placed tightly around the wrist but
must not constrict.

5. Measuring blood pressure

• Sit in a relaxed position.
• Ensure that your arm is supported
and bend it so that it is at the level
of your heart (see illustration).
• Before measurement allow an
adequate relaxation time of 3 – 5
minutes.
• Now press the Start/Stop button
measurement.
• The cuff will now inflate automatically to 180 mmHg.
• When the 180 mmHg pressure is reached, the pres-
sure is automatically released from the cuff and a
beating heart appears in the display.
• If the preset pressure of 180 mmHg is inadequate
during inflation, the device automatically pumps up to
a higher pressure.
• Your blood pressure readings and pulse rate will then
appear in the display.
• To switch off and release the pressure, press the
Start/Stop button again
• • • • • • • • • • • • •
4
to start the
4
.
• If you forget to switch off the computer, it will switch
off automatically after 3 minutes.
• You can interrupt measurement at any time by pres-
sing the Start/Stop button
6. Display of the readings saved
The computer automatically saves the blood pressure
readings of the last 60 measurements.
When the 60 memory locations are exceeded, the current
oldest value is deleted.
You can display the memory as follows:
• Press the memory button M
switched off. The last reading measured appears.
• You can call up all individual readings saved by press-
ing the memory button M repeatedly.
• The memory location number is shown in the display
at bottom right. The date and time of the individual
measurement are shown in the top part of the display.
• The last result obtained is stored in the first memory
location. As soon as a new result is obtained, this
appears in the first memory location and the older
result moves down to the next location.
15
4
.
3
with the computer