bürkert 8311 Bedienungsanleitung Seite 18

8311
Calibration Mode (see page 21)
Access to the programming of all the parameters (unit, transistor
outputs, filter, 4...20 mA output, bargraph, behaviour of the outputs if
the pressure is outside the measuring range and/or when an error is
displayed, access code to the Calibration and Test modes).
From the Calibration mode, you can go back to the Normal Mode.
Reminder:
1 bar = mbar
1000 14.5038
1 bar = ft H O in. H
2
33.4553 401.463
Test Mode (see page 31)
Entering a theoretical pressure value to test the configuration pro-
grammed in the Calibration mode. Access to zero point adjustment,
K-factor adjustment, current output adjustment, reset of the Calibra-
tion and/or Test modes. From the Test mode, you can go back to the
Normal Mode.
psi atm kPa
0.98692 100
O in. Hg kp/cm
2
29.53 1.01972
18
MPa mH O
2
0.1 10.1972
2
mmHg
750.064