Removing The Rear Wheel - SWM SIX DAYS Bedienungsanleitung

REMOVING THE REAR WHEEL

Unscrew the nut (1) of the wheel shaft (2) and
extract it. It is not necessary to loosen the chain
tensioners (3); in this way, the chain tension will
remain unchanged after reassembly.
Extract the complete wheel, paying attention to the
spacers located at the hub sides.
To reassemble, reverse the above procedure
remembering to insert the brake disc into the calliper.
Note
Do not operate the rear brake pedal when the wheel
has been removed; this causes the calliper pistons
to move forwards.
After removal, lay down the wheel with brake disc
facing up.
After reassembling the wheel, depress the brake
pedal until the pads are against the disc. (Tightening
torque of nut (1) 120 Nm).
SIX DAYS
49 -
EN