Chain Adjustment; Blow-By Tube Cleaning - SWM SIX DAYS Bedienungsanleitung

SIX DAYS

CHAIN ADJUSTMENT

Chain should be checked, adjusted and lubricated
as per the Maintenance Chart to ensure safety and
prevent excessive wear. If the chain becomes badly
worn or is poorly adjusted (i.e., if it is too loose or too
taut), it could escape from sprocket or break.
Make sure that the chain features a slack (A)
measuring approximately 20 mm, as shown in the
nameplate (1) on swingarm.
If this is not the case, proceed as follows:
- On the right side, loosen the nut (2) securing the
wheel shaft using a socket wrench;
- Loosen the lock nuts (3) on both the chain
tensioners and operate on the nut (4) to obtain the
correct tension value.
Note
Adjust both chain tensioners in the same way.
- Adjust the lock nuts (3) to a tightening torque of
22Nm and the wheel shaft nut (2), to a tightening
torque of 80 Nm.
After adjustment, always check wheel alignment
and that the arrow is 20 mm.
46 -
EN
1

BLOW-BY TUBE CLEANING

- Unscrew the two screws (1) and move the canister
(2) to the side.
- Periodically check the blow-by tube (3) according to
the maintenance table. To clean the tube, open out
the clip (4) and remove the cap (5) discharging any
accumulated deposits into a container.
- Refit the cap (5) operating in reverse order from
removal.
2
5
1
3
4