Connections At Rear Of Distimatic Pro - Heidolph Hei-VOLUME Distimatic Pro Aufbauanleitung

Assembly

Connections at rear of Distimatic Pro

The following figure shows the rear of the Distimatic Pro with standard plug-in cards
and optional expansion cards. The actual assignment depends on the scope of the
order!
The coded connectors of the system's sensors and valves are plugged into the connec-
tion sockets of the sensor cards, are identified automatically and are assigned in the
device software.
In addition, observe the marking of the existing connection sockets and all information
on replacing existing or installing optional expansion cards in the supplied assembly
documentation!
The NOT-HALT EXTERN/EMERGENCY STOP connection socket
on the automatic module must be assigned, i.e., either the inte-
grated connector (as shown in the following figure) or an external
emergency stop switch must be plugged in here. Otherwise, the
automatic module is in the emergency stop state and no processes
can be started!
94