Configuring Interfaces; Configuring Wi-Fi - Hella Gutmann mega macs X Bedienungsanleitung

Hella Gutmann
• Display settings
• Confirmation of General terms and conditions
• Printer settings
Proceed as follows to perform a factory reset:
1. Select > Settings > Device > Version.
2. Click to >Start factory reset<.
3. Observe the confirmation prompt.
4. Affirm the confirmation message.
ð The system will be automatically reset to the state of delivery.

8.7. Configuring interfaces

Here you can set the interfaces for Wi-Fi and Ethernet.
Configure the interfaces for Wi-Fi and Ethernet under
Configure the interfaces for the printer under

8.7.1. Configuring Wi-Fi

Make your Wi-Fi settings here.
Wi-Fi is a wireless local area network. Data is transmitted wirelessly via a router and DSL modem (access point). The re-
spective devices register in the Wi-Fi router.
8.7.1.1. Searching and Installing a Wi-Fi Interface
Proceed as follows to connect the diagnostic device to a network (router) through Wi-Fi:
1. Select > Settings.
2. Select >Device<.
3. Select >Wi-Fi<.
4. Select the check box Activate Wi-Fi to view available wireless networks. The available wireless networks are dis-
played.
ð The available wireless networks are displayed.
5. Select the requested wireless network.
6. Open the list under IP address mode with
ð If >Determine automatically (DHCP)< (recommended) is set, the DHCP server of the network will assign an IP
address to the mega macs X automatically. This option is set ex works.
mega macs X
> Settings > Device.
> Settings > Print.
.
Configuring the mega macs X | 8.
145