Hella Gutmann mega macs X Bedienungsanleitung Seite 161

Hella Gutmann
Symbols Name
Maximum value
Use this symbol to view the maximum value of the entire measurement sequence under >Mea-
surements<.
Measured variables
This symbol marks the measured variables under >Measurements<.
Measured value
Use this symbol to view the currently measured value under >Measurements<.
Period duration
Use this symbol to view the duration of one signal period under >Measurements<.
Duty cycle
Use this symbol to view the percental relation (duty cycle) of the time the signal is switched on
and switched off under >Measurements<. One signal period is 100 %. This indication mode is
suitable for square wave signals only.
Frequency
Use this symbol to view the signal frequency under >Measurements<.
Peak-to-peak value
Use this symbol to view the maximum distance between the upper and lower signal peak of the
entire measurement sequence under >Measurements<.
Lower pulse width (-)
Use this symbol to view the duration of the lower signal amplitude under >Measurements<.
Upper pulse width (+)
Use this symbol to view the duration of the upper signal amplitude under >Measurements<.
Zero reset
Use this symbol to place the voltage curve on the zero line under >Measurements<. In this way,
you can compensate for interference voltages and measuring range tolerances.
Reset zoom
Use this symbol to reset the zoomed view during the measurement process under >Measure-
ments<.
Guided measurement
Use this symbol to start a guided measurement under >Measurements<.
mega macs X
Working with the mega macs X | 9.
161