Mounting The Wheel Rails On The Base Frame; Mounting The Lamp Mount - Eufab 11417 Bedienungsanleitung

4 x Link screw M6 x 75
4 x Wheel stopper
2 x Rail connector
2 x Connecting element with metal loop
4 x Washer 11.9 x 6.5 x 0.9
4 x Wing nut M6
4 x Tensioning strap, small
Place the 4 rail halves in front of you as shown on the pictures below,
and guide the components in the sequence shown under the rail into the
existing link.
Rail 1, left half
Rail 1, right half
Rail 2, left half
Rail 2, right half
Pull one tensioning strap through each wheel stopper. Now insert one
wheel stopper in each wheel rail into the topmost link.
Make sure that the wheel stopper can be pushed from the inside to the
outside towards the wheel.
10
Connect the right and left halves of rail 1 with a rail connector.
Insert the connecting element from the top with the threaded bolt in the
drilled holes of the wheel rail. From below, insert the metal loop with the
ridges facing outwards, over the threaded bolt and screw fi rmly with two
washers 11.9 x 6.5 x 0.9 and two wing buts.
Repeat this assembly process for rail 2.

5.1.3 MOUNTING THE WHEEL RAILS ON THE BASE FRAME

4 x Washer 17.6 x 6.5 x 1.1
4 x Wing nut
Insert the long screws of the wheel rails through the drilled holes of the
base frame. Make sure that the wheel rail with the additional short link
screws is secured at the back of the base frame. Align the wheel rails
centrally on the
base frame. Screw the wheel rails into place with the washers 17.6 x 6.5 x
1.1 and wing nuts.

5.1.4 MOUNTING THE LAMP MOUNT

Lamp mount, left and right