Adjustment Of The Azimuth - Clearaudio TT2 Bedienungsanleitung

User manual / Bedienungsanleitung
7.3 Adjustment of the azimuth (vertical position of the cartridge)
Please be extremely careful during the following steps. Please always lift the cartridge
away from the record surface.
Pic. 25: Distance between headshell screw
and diamond of the cartridge about 6.2cm / 62mm
a
a = b
Pic. 26: Azimuth adjustment
Pic. 27: Supporter of the folding base
Page / Seite 16
Adjust the approximate fore/aft position of the
cartridge.
The optimal distance of the stylus to the middle of the
headshell carriage is 62mm (see Pic. 25).
Use the Mini Level Gauge provided for the following
azimuth setting.
Place the gauge centered on the top of the headshell
(see Pic. 26) of the raised cartridge.
Lower the cartridge onto the platter and check the
azimuth level with the bubble of the Mini Level Gauge.
With the cartridge raised away from the record surface,
slightly loosen the headshell tube locking screw and
rotate the headshell in the appropriate direction to set
the correct azimuth.
When the adjustment is complete, re-tighten the
headshell tube locking screw and remove the Mini
Level Gauge from the headshell. Now you can set the
correct tracking force of your cartridge according to
b
the manufacturer's instructions. For the correct setting
we recommend using the Clearaudio Weight Watcher
digital touch cartridge scale (Art. No. AC163, also
available at www.analogshop.de).
For a perfect sound, we recommend checking the tracking force,
azimuth and VTA settings again and correcting them if necessary.
After completing all adjustments, please make sure that the signal
cable forms a smooth loop upwards and that the supports (Pic. 27) of
the folding base are screwed up so that the tonearm gently rests on
them when in the horizontal position.
TT2
The Clearaudio tonearm is now fully adjusted and ready to play.
© clearaudio electronic GmbH, 2022-01