Mounting The Cartridge - Clearaudio TT2 Bedienungsanleitung

User manual / Bedienungsanleitung
Pic. 17: Final position after inserting the headshell tube
To fix the headshell tube, slide the tonearm carriage back towards the tonearm base.
Through the small opening in the cover plate you can tighten the headshell tube easily with the
1.5mm hex wrench (Pic. 19).
Pic. 19: Fixing the headshell tube (rear view)

5. Mounting the cartridge

The following settings require mounting the cartridge on the headshell.
Always follow the cartridge manufacturer's instructions.
Use the screws provided to mount the cartridge onto the headshell.
Leave the stylus protector on your cartridge to avoid any damages!
Please note:
This tonearm is suitable for all cartridges with a weight of 7g and above.
If your cartridge is lighter, please use an additional weight (headshell plate).
Available through your dealer/distributor or Clearaudio: info@clearaudio.de
Now you can connect the respective signal cable with the matching color pins of the cartridge.
Please note the following colour coding:
Red:
right channel / R+
Green:
right channel / R-
White:
left channel / L+
Blue:
left channel / L-
Page / Seite 12
Pic. 18: Correct position of the headshell tube
© clearaudio electronic GmbH, 2022-01