Safety Instructions - Clearaudio TT2 Bedienungsanleitung

User manual / Bedienungsanleitung
1. Maintenance
• Please make sure that the precision dry ball bearings are not touched, cleaned or lubricated in
any way.
• Never move or readjust the screws in the tonearm carriage. They should be adjusted only by
qualified dealers or at the Clearaudio factory.
• Use a cotton bud and a commercially available glass cleaner to clean the glass tube. Put some
glass cleaner on the cotton bud and slide it through the glass tube with a movement from the
inlet to the outlet groove.
2. Transportation
Should further transportation of the
packing material. Otherwise serious damage could occur.
During any transportation of the tonearm, always protect the carriage with a piece of
foam so that the carriage cannot move during transportation.
When repackaging the tonearm, please follow in reverse the steps indicated in this
manual for installation and setup.
3. Service
If any servicing or repair of a Clearaudio product is necessary, please first contact your dealer or
distributor. Alternatively contact Clearaudio directly and we will advise you of your nearest service
location.
PLEASE RETAIN ALL ORIGINAL PACKAGING. You will need it if this product has to be transported
and/or shipped. Any further questions you may have about this product should be directed to your
local dealer.

4. Safety instructions

Disposal
This product is not allowed to be disposed with household waste.
WEEE Reg.No.: DE26004446
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not handle the mains lead with wet hands.
No naked flame sources, such as lighted candles, should be placed on the equipment.
Only for use on turntables.
Made in Germany
Safety instructions
TT2
tonearm be necessary, please always use the original
Page / Seite 3