Tt2 Set Up - Clearaudio TT2 Bedienungsanleitung

User manual / Bedienungsanleitung
TT2
3. set up
approx. 1cm
Pic. 9: Fixing the height adjustment
Pic. 10: Remove the height adjustment screw
Pic. 11: Mounting the tonearm
Pic. 12: Secure the tonearm
Page / Seite 10
Please remove the foam used for safe transportation
of the tonearm carriage.
Turn the height adjustment screw clockwise until
the gap between head of the screw and tonearm
housing is approx. 1cm.
Remove the height adjustment screw by loosening
with 2.5mm hex wrench (Pic. 10).
Now open the folding base so that the rods are
horizontal and place the tonearm on the support
bars until the lower end of the height adjustment
screw becomes visible in the height adjustment
screw hole (Pic. 11).
Secure this setting by re-inserting the height
adjustment screw and tightening it by hand
(Pic. 12).
© clearaudio electronic GmbH, 2022-01