Inserting The Headshell Tube - Clearaudio TT2 Bedienungsanleitung

User manual / Bedienungsanleitung
Pic. 13: Adjustment of the angle
Pic. 14: Level Gauge

4. Inserting the headshell tube

For the next step remove all counterweights from the headshell tube.
Slide the tonearm carriage toward the tonearm base.
Through the small hole in the cover plate, you can loosen the headshell tube fixing screw with the
1.5mm hex wrench (Pic. 15).
Insert the headshell tube into the tonearm carriage, rotating it 90 degrees so that you can position
the positioning pin behind the forward tonearm bar. Then you can rotate the headshell tube back to
its upright position (Pic. 16-18).
Pic. 15: Inserting the headshell tube
Made in Germany
Now you can align the tonearm's horizontal level by
adjusting the angle with the grub screw pictured in
Pic. 13, using a hex wrench #2.
Make sure that the bubble of the level gauge
(Pic. 14) is levelled in the middle of the gauge.

Pic. 16: Turning the headshell tube
positioning pin
Page / Seite 11