Clearaudio TT2 Bedienungsanleitung Seite 8

User manual / Bedienungsanleitung
2.2 Mounting the tonearm base and folding base on a Clearaudio Innovation series
turntable
Please check that the correct tonearm base is mounted on your turntable (Pic. 5).
Pic. 5: Tonearmbase for Innovation
Serie (Art. No. AC030-7)
Next, fit the folding base and the dedicated height adaptor with the screws provided (Pic. 1, #5; page
5) and the hex wrench #3 (Pic. 6). Please make sure that the bases sit perfectly on the turntable.
To mount the height adaptor with 14.5mm and 10mm you will need the M4 x 40 screws which are
already pre-mounted. If you don't need the height adaptor, then use the M4 x 30 screws
(Pic. 1, #5; page 5).
The height adaptor will be required depending on the dimensions of the turntable and cartridge.
Our dealer/distributor will help you or contact Clearaudio directly.
Now you can tighten all the screws (see Pic. 7).
Pic. 6: Mounting the folding base
Pic. 7: Tightening the screws
Page / Seite 8
If the tonearm base is already pre-assembled, it is in a position
which is optimized for the packaging. The position of the tonearm
base will be correct during the adjustment of the tonearm.
If not, then remove previous tonearm base by loosening the screw
of the aluminium base with a 7mm hex wrench.
Exchange the tonearm base for the correct one (see Pic. 5) and
place it so that the long side of the tonearm base points counter-
clockwise. Now you can loosely tighten it so that the tonearm base
is still rotatable.
Folding base
Height adaptor
Tonearm base
© clearaudio electronic GmbH, 2022-01