Adjustment Of The Tracking Force; Adjustment Of The Azimuth - Clearaudio Clarify Bedienungsanleitung

User manual / Bedienungsanleitung

5.3 Adjustment of the tracking force

To increase or lower the tracking force, you have to turn the adjustment screw at the end of the
tonearm.
Pic. 13: Adjustment of the tracking force
Please follow the instructions of the respective cartridge manufacturer.
For the correct setting we recommend using the „Clearaudio Weight Watcher touch" digital cartridge
scale (Art. No. AC163, also available at www.analogshop.de).

5.4 Adjustment of the azimuth

Please note:
The azimuth is already set at the factory.
To increase or lower the tracking force, you have to turn the adjustment screw at the end of the
tonearm.
The azimuth is the angle of the cartridge stylus to the record surface. Viewed from the front, the
cartridge needle have to be vertical to the record.
Pic. 14: Azimuth adjustment
After you have found the correct position, carefully tighten the small hex screw again without
changing the previously selected position.
To check this adjustment, we recommend the Clearaudio „Mini Level Gauge" (Art. No. AK001,
available at www.analogshop.de).
Page / Seite 12
red arrow (to the end of the tonearm)
= lower tracking force ->
turn the knob clockwise
green arrow (to the beginning of the tonearm)
= more tracking force ->
turn the knob anti-clockwise
If you still want to optimize the azimuth, lower the
cartridge onto the record surface and check the position
of the needle.
To change the azimuth, please proceed as following:
Loosen the screw (hex wrench #2) on the bottom side of
the tonearm tube near the headshell.
Now you can adjust the azimuth by turning the headshell
in the tonearm tube.
© clearaudio electronic GmbH, 2022-01