Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(21)
2. Press and hold the
ton (21) for more than 5 seconds to enter
the selection menu for setting the water
hardness.
3. Press the
programme button repeated-
ly until the display (3) shows the desired
setting. You can select a hardness level
from
to
H1
H6 .
4. Press the
button to save the selected
hardness level.
The hardness level setting is saved.
Automatic regeneration
In order to make sure that the water soften-
ing system works, the water softening sys-
tem is automatically regenerated at regular
intervals.
The regeneration process of your appliance
begins with the drying cycle. The water and
energy consumption then increases and the
duration of the programme is extended. There
is no regeneration process in the short cycle.
The frequency of the regeneration process
depends on the selected water hardness:
Regeneration process
°dH
Setting
0–5
H1
6–11
H2
12–17
H3
18–22
H4
23–34
H5
35–55
H6
Installation, connection and initial commissioning
programme but-
all
X Programme
sequences
–
10
5
3
2
1
Example ECO programme: with a water
hardness level of H3 and under laboratory
conditions, the duration of the programme in-
creases by 4 minutes. The energy consump-
tion increases by 0.02 kWh and the water
consumption by 2.0 litres.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
See chapter "Dishwasher operation" from
page EN-22 for the procedure.
Page EN-39
Werbung
Inhaltsverzeichnis
