hanseatic HGTI6082B14U7709WS Gebrauchsanleitung Seite 62

Page EN-14 Dishwasher detergents, rinse aids and dishwasher salts
1. Open the cover of the rinse aid dispenser
(36).
2. Pour rinse aid into the opening until the
"max" mark.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the rinse aid dispenser cover again.
Changing rinse aid setting
We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Quickly take the following steps, otherwise
interrupt the process from (see "Setting the
water hardness level" on page EN-38).
1. Switch on the appliance with the
ton (1).
2. Press the programme button (21) for
5 seconds within 60 seconds of switching
on the appliance.
3. Push the button (26) to switch to setting
mode.
The indicator (14) will flash. The cur-
rent value (d1 to d5) will illuminate on the
display (3).
4. Select the desired dose using the pro-
gramme button : from d1 (low) to d5
(high).
5. After 5 seconds the appliance saves the
setting, and the display (3) returns to the
original indicator. You can alternatively
also push the button to leave the set-
ting menu.
but-