Built-In Installation (For The Integrated Model) - hanseatic HGTI6082B14U7709WS Gebrauchsanleitung

Page EN-34 Installation, connection and initial commissioning
(45)
4. Affix the enclosed protective film (45) to
the bottom of the worktop. In this way,
you will avoid damage to the worktop as
a result of hot steam which may be emit-
ted from the dishwasher if the dishwasher
door is left open.
5. Place the dishwasher in the desired po-
sition.
6. In order to compensate for uneven floor
surfaces and set up the dishwasher hori-
zontally, you can screw the four adjusta-
ble feet (41) in or out. The adjustable feet
have slots around their circumference.
Insert a screwdriver and turn the adjust-
able foot.
Use a spirit level to set up the dishwasher.
Built-in installation
(for the integrated model)
1. Switch the fuse off.
2. Remove cardboard, polystyrene and ad-
hesive strips from the inside, if you have
not already done so.
3. Affix the enclosed protective film (45) to
the bottom of the worktop. In this way,
you will avoid damage to the worktop as
a result of hot steam which may be emit-
ted from the dishwasher if the dishwasher
door is left open.
(48)
(41)
1. Insert the two mounting brackets (48) into
the front slots on the top of the appliance
so that you can screw the appliance to the
worktop later on.
(45)