AEG Protect C 1000 Bedienungsanleitung Seite 93

"Control" / Command
Go to Bypass / Normal
Battery Test
Reset Error State
.3.5 IDENTIFICATION
Activate this menu item to view the following sub-menu items: "Type / Model", "Part
number , Serial number and finally the current UPS .rehto eht retfa eno noisrev
"erawmrif
Beschreibung
Possibility to change
operation mode.
If the UPS is not in Normal Mode or
Bypass Mode this option is not used
and should not be displayed as a
control option.
Schedule Battery Test:
yes | Cancel Battery test: no
Starts a manual battery test.
Reset Alarms: yes | no
Manually clears any latched alarms,
such as bad battery detected or DC
Bus over voltage/ under voltage.
With an active battery fault alarm,
the battery test status will also
simultaneously reset to "Not
Tested".
EN