AEG Protect C 1000 Bedienungsanleitung Seite 82

To ensure correct operation of the UPS and its ancillary equipment, it is necessary to
equip the power cord with an appropriate fuse. For all models in the Protect C series
connection is made via the supplied mains lead to a standard electrical outlet. Utilize a
su icient fuse rating in your sub-distribution. In particular, the Protect C 3000
requires its own 1 A protection. Initially, do not yet insert the safety plug of the power
cord in the dedicated electrical outlet.
.4 CONSUMER CONNECTION
Before making the connection of loads to the UPS, please check that the specified
power rating on the type rating plate is greater than or equal to the sum of consumer
services. Connect the provided consumers with the outlets of your UPS. To do this,
use the enclosed consumer connection lines. Initially consumers must be turned o . If
additional load connection cables are required, please contact your dealer.
Before making the connection of loads to the UPS, please check that the specified
power rating on the type rating plate is greater than or equal to the sum of consumer
services. Connect the provided consumers with the outlets of your UPS. To do this,
use the enclosed consumer connection lines. Initially consumers must be turned o . If
additional load connection cables are required, please contact your dealer.
The UPS consumer load should not exceed the specified rated load of the devices at
any time. If a device becomes overloaded, the red fault LED lights up, accompanied by
a beep. The supply to the connected loads is dependent on the magnitude of the
overload valid for a certain time however, the connected load must be reduced
immediately. Non-observance of the device overload can lead to a total loss of all
UPS functions!
Avoid short-term device overloads, which can arise, for example, when connecting a
laser printer or a laser fax machine. Do not connect household appliances and
machine tools to the UPS.