AEG Protect C 1000 Bedienungsanleitung Seite 92

.3.3 MEASUREMENTS
Select this menu item to find the following measurements in this order:
Power Usage E iciency
Output
active and apparent power
Output
current and power factor
Output
voltage and frequency
Input
voltage and frequency
Battery
voltage and charge state
DC bus
intermediate circuit voltage
External battery modules
Total kWh consumption
If you want to see any particular measurement on the screen permanently, you can
free e the screen in the Measurements menu. To do so, press ▲ and ▼ for
approx. 3 seconds at the same time until a small key appears in the upper right-hand
corner of the display. Press the two buttons again at the same time for approx. 3
seconds to cancel this setting control.
.3.4 CONTROL
During normal mode, you can active this menu item to access the following
sub-menu items: Go to bypass , Battery test and reset error state .
Depending on the operating mode, only those sub-menu items that are available will
appear.
W VA
A
V
V
V
V
kWh