AEG Protect C 1000 Bedienungsanleitung Seite 65

6
HANDLING
EN
PROTECT C is designed and constructed so that all necessary steps for start-up and
operation can be performed without any internal manipulation of the unit. Mainte-
nance and repair work may only be performed by trained and qualified personnel.
Illustrations are provided to clarify and facilitate certain steps.
If danger to personnel and the unit cannot be ruled out in the case of certain work, it
is highlighted accordingly by pictograms explained in chapter 3.
COPYRIGHT
No part of these operating instructions may be transmitted, reproduced and/or
copied by any electronic or mechanical means without the express prior written
permission of AEG. © Copyright AEG 201 . All rights reserved.