Slave Mode - Cameo STUDIO PAR 4 G2 Bedienungsanleitung

Step 3
Step 4
Step 5
Step 6
Step 7
Step 8

SLAVE MODE

Standard Slave mode: Starting from the main display, press MENU to enter the main menu.
to select the menu item Slave, confirm with ENTER, select Slave Group 0 and
Now use and
again confirm with ENTER. Connect the slave and the master units (same model, same software
version) using a DMX cable, and enable one of the standalone modes on the master unit (Auto,
Static, Colour Preset, Play Loop). The slave unit will now follow the master unit.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
Advanced slave mode: If you wish to control the slave units in master/slave mode using one of
the Auto or Playback Loop standalone modes, the control signal can be reproduced with a time
delay of up to 24 steps. The delay is set in the submenu item Delay in the relevant standalone
mode; the delay factor is set in the slave menu of the corresponding spotlight. This is a simple
way to create a running light effect with a large number of spotlights that are all the same model
and have the same software version. This is otherwise only possible using a suitable DMX control-
ler and time-consuming programming.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
20
15 colours from Colour Preset
4 colours from User Colour
Blackout
Skip step
"
"
"
"
"
Slave Group
00
Slave Group
00 - 24
Red-Cold White
User Color 1 – User Color 4
Black
Skip Step
"
"
"
"
"