Cameo STUDIO PAR 4 G2 Bedienungsanleitung Seite 21

Assign the spotlights to one of up to 24 groups (plus Group 0) according to preference, whereby
several spotlights can be assigned to one group. The group number is also the factor by which the
delay time set in the master unit is multiplied.
Setup example:
Delay Group 0
no Delay
Master Unit Mode
Slave
Loop Delay 0.5s
Group 0
SYSTEM SETTINGS (Settings)
Starting from the main display, press MENU to enter the main menu. Using and , select the
menu item Settings and confirm with ENTER.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the submenu items (see table, select with
confirm with ENTER, change value or status with
Settings
Disp Rev = Rotate display
Display = Display lighting
Off Timer
Signal = Operational status with
Fail DMX signal fault
PWM = LED PWM frequency
Delay Group 1 Delay Group 2
0,5s Delay 1s Delay
Mode Mode
Slave Slave
Group 1 Group 2
and , confirm with ENTER).
Off No display rotation
On Display is rotated by 180° (e.g. for over-
head installation)
Off after Deactivates after approximately 20 sec-
20s onds of inactivity
Always On On permanently
Hold Last command is retained
Blackout Activates blackout
Fade 10s fade to blackout
User Colour User Colour 1 is activated
1
650Hz, Select LED PWM frequency
1530Hz,
3600Hz,
12000Hz,
18900Hz,
25000Hz
Delay Group 3 Delay Group 4
1,5s Delay 2s Delay
Mode Mode
Slave Slave
Group 3 Group 4
Mode
Slave
Group 3
Mode
Slave
Group 3
Delay Group 5
2,5s Delay
Mode
Slave
Group 5
and ,
21