Slave Mode - Cameo STUDIO PAR TW Bedienungsanleitung

SLAVE MODE

Standard Slave mode: Starting from the main display, press MENU to enter the main menu.
Now use and to select the menu item Slave, confirm with ENTER, select Slave Group 0
and again confirm with ENTER. Connect the slave and master unit (same model, same software
version) using a DMX cable, and activate one of the stand-alone modes on the master unit (Static,
CCT Preset, Playback Loop). The slave unit will now follow the master unit.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
Advanced slave mode: If you wish to control the slave units in master / slave mode using the
standalone mode Playback Loop, the control signal can be reproduced with a time delay of up
to 24 steps. The delay is set in the submenu item Delay in the relevant standalone mode; the
delay factor is set in the slave menu of the corresponding spotlight. This is a simple way to create
a running light effect with a large number of spotlights that are all the same model and have
the same software version. This is otherwise only possible using a suitable DMX controller and
time-consuming programming.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
Assign the spotlights to one of up to 24 groups (plus Group 0) according to preference, whereby
several spotlights can be assigned to one group. The group number is also the factor by which the
delay time set in the master unit is multiplied.
Setup example:
Delay Group 0
Master Unit
Loop Delay 0.5s
18
Slave Group
00
Slave Group
00 - 24
Delay Group 1
no Delay 0,5s Delay
Mode Mode
Slave
Slave
Group 0 Group 1
Delay Group 2 Delay Group 3
1s Delay 1,5s Delay
Mode Mode
Slave Slave
Group 2 Group 3
Mode
Slave
Group 3
Mode
Slave
Group 3
Delay Group 4 Delay Group 5
2s Delay 2,5s Delay
Mode Mode
Slave Slave
Group 4 Group 5