Cameo STUDIO PAR TW Bedienungsanleitung Seite 19

SYSTEM SETTINGS (Settings)
Starting from the main display, press MENU to enter the main menu. Using and , select the
menu item Settings and confirm with ENTER.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the submenu items (see table, select with
confirm with ENTER, change value or status with
Settings
Disp Rev = Rotate display
Display = Display lighting
Off Timer
Signal = Operational status
Fail with DMX signal fault
PWM = LED PWM frequency
Dimmer = Dimmer curve
Curve
and , confirm with ENTER).
Off No display rotation
On Display is rotated by 180° (e.g. for over-
head installation)
Off after Deactivates after approximately 20 sec-
20s onds of inactivity
Always On On permanently
Hold Last command is retained
Blackout Activates blackout
Fade 10s fade to blackout
User Colour User Colour 1 is activated
1
650Hz, Select LED PWM frequency
1530Hz,
3600Hz,
12000Hz,
18900Hz,
25000Hz
Linear Light intensity increases linearly with DMX
value
Exp (Expo- Light intensity can be finely adjusted at
nential) lower DMX values and broadly adjusted at
higher DMX values
Logarithmic Light intensity can be broadly adjusted at
lower DMX values and finely adjusted at
higher DMX values
S-curve Light intensity can be finely adjusted at
lower and higher DMX values and broadly
adjusted at medium DMX values
and ,
19