Cameo STUDIO PAR TW Bedienungsanleitung Seite 14

CONFIGURE DMX START ADDRESS
Starting from the main display, press MENU to enter the main menu. Now use
the menu item DMX address and confirm with ENTER. Now use the
ure the desired DMX start address and press ENTER to confirm (highest value dependent upon
activated DMX mode).
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
CONFIGURE DMX MODE
Starting from the main display, press MENU to enter the main menu. Now use
the menu item DMX Mode and confirm with ENTER. Again use
mode and confirm with ENTER (DMX modes with DMX delay channel are identified with "D"). Ta-
bles with the channel assignment of the different DMX modes can be found in these instructions
under DMX CONTROL.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
DMX DELAY
The DMX Delay function is a simple way to create a running light effect with a large number of
spotlights that are all the same model and that are all running the same software version. This
is otherwise only achievable with a suitable DMX controller and time-consuming programming.
All the spotlights used (same models, same software version) are set to the same DMX operating
mode with DMX delay channel and controlled via the same DMX start address.
Setting the DMX delay:
Starting from the main display, press MENU to enter the main menu. Now use
the menu item DMX Delay and confirm 2x with ENTER.
14
DMX Address
001 - 512
DMX Mode
1CH DIM
D5CH 8Bit
2CH CCT
3CH 8Bit
D4CH Strobe CCT
8CH 16Bit
11CH Full Access
or to select
and buttons to config-
or to select
or to select the desired DMX
or to select