Description Of Appliance; Technical Specifications; Recommended Open-Outlet Taps - clage M3 Montageanleitung

EN

Description of appliance

2. Description of appliance
This instantaneous water heater is intended to provide the economical heating of water suffi-
cient for a single outlet, i.e. handwash basin, and must be connected to a special open-outlet
tap to avoid any overpressure.
When the hot water tap is opened, the instantaneous water heater switches itself on auto-
matically and heats the water as it passes through the appliance. It is only then that the appli-
ance uses electricity. The temperature increase depends on the flow rate.

2.1 Technical specifications

Type
Energy efficiency class
Capacity
Max. operating pressure
Heating system
Min. water resistance at 15 °C
Max. water inlet temperature
Rated voltage
Rated power
Rated current
Required min. cable cross-section
Hot water output at ∆t = 25 K
Switching on at
Switching off at
Approx. weight when filled with water
Protection class
Marking / Approvals
*) The declaration complies with the preliminary requirements of the EU regulation No 812/2013 being binding as of September
2015.
1) The specific resistance can be asked for at your water distribution company.
2) Temperature increase from e. g. 15 °C to 40 °C.
2.2 Recommended open­outlet taps
Type
Art. No.
Litre
MPa (bar)
Ωcm
1)
°C
kW
A
mm
2
2) l/min
l/min
l/min
kg
SNM
1100-04200 1100-04410
M 3 M 4
0 (0); Open outlet only!
IES® bare wire heating system
1~ / N / PE 230 V AC
3.5 4.4
15.2 19.1
1.5 2.5
2.0 2.5
1.3 1.8
1.0 1.4
see rating plate
END EWT
1100-04420
22
M 6
A *)
0.2
1100
20
2~ / PE 400 V AC
5.7
24.8 16.3
4.0
3.3
2.2
1.7
1.5
IP 25
AEN
1100-04255
M 7
6.5
1.5
3.7
2.4
2.0