Disposal; Disassembly; Environment And Recycling - clage M3 Montageanleitung

EN

Disposal

6. Disposal

6.1 Disassembly

1. Switch off the power supply to the instantaneous water heater.
2. Close the shut-off valve in the inlet pipe.
3. Disconnect the electrical connection in the appliance junction box or disconnect the protec-
tive earth plug if the appliance is fitted with a plug.
4. Disconnect the water pipes from the connectors of the appliance. This can cause water leak-
age.
5. Remove the appliance from the wall bracket. To do so, insert the tip of a wide screwdriver
as far as it will go into the latch between the water connection pieces and push the latch
slightly upwards. Tilt the appliance forward by max. 15° and remove it by lifting it upwards.
6. Unscrew the wall bracket from the wall.
Fig. 13: "Removing the appliance from the wall bracket"

6.2 Environment and recycling

vent any potential negative effects on human beings and the environment that could arise
from inappropriate handling of these devices at the end of their service life. Please contact
your local authority for further details of your nearest designated collection point or recycling
site.
Business customers: If you wish to discard electronic equipment, please contact your dealer or
supplier for further information.
Your product was manufactured from high-quality, reusable materials and
components. Please respect in case of discarding that electrical devices
should be disposed of separately from household waste at the end of
their service life. Therefore, please take this device to a municipal collec-
tion point that accepts electronic scrap on a free of charge basis.
Disposing it correctly will support environmental protection and will pre-
34