Cp 5511 (Mpi) Parameter Assignments - Siemens SIMATIC NET CP 5511 Installationsanleitung

C79000-Z8974-C70-02CP 5511 Communications Card under Windows 98, NT 4.0, 2000 Professional

7.3.4 CP 5511 (MPI) Parameter Assignments

"CP 5511 (MPI)" Using the "CP 5511 (MPI)" standard parameter assignment allows
access to MPI networks.
Parameter
Assignment
The "Network Parameters" are valid for the entire MPI network and
must match up for each node. The transmission rate for MPI networks
can be set to specific values selected in a list box. It is not possible to
set the bus parameters.
In the "Properties" dialog, you can modify the MPI bus parameters.
Under "Station Parameters", you can set the local parameters: the most
important of these is the Profibus address. With the "Programming
device / PC is the only master on the bus" check box, you can decide
how the interface is entered into the PROFIBUS ring. If this check box
is deactivated, the interface can be included in a ring that is already
active while the interface is turned on. (default for MPI networks).
© Copyright by SIEMENS AG
31