Removing Of The Shipping Bolts - Pkm WA6-ES1510 Bedienungsanleitung

be damaged. Do not install the appliance in a room where explosive or flammable
gases are stored.
5. Protect the appliance from direct sunlight.
6. Install the appliance in a dry and well-ventilated place. The room temperature
must be higher than 0 °C.
7. Install the appliance in a suitable position with an adequate distance from sources
of heat and cold.
8. Do not install the appliance on a carpet / fitted carpet.
9. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
10. If you install the appliance on a wooden floor, you must also place it on a
plywood panel (60.00*60.00 cm) at least 3.00 cm thick to distribute the weight
of the appliance. Fix and secure the plywood panel properly to the wooden floor.
11. All required installations for the electric and water supply must be carried out by
a qualified professional.
12. Connect the appliance to the mains properly.
13. The nameplate is situated at the back of the appliance.

2.3 Removing of the shipping bolts

NOTICE! First remove the bottom equipment protection
remove the shipping bolts
NOTICE! Remove the shipping bolts before the initial use of the appliance.
Otherwise, the appliance may be irreparably damaged irreparably. RISK
OF DAMAGE!
NOTICE! Ensure that the bottom equipment protection has been removed
completely before you use the appliance; otherwise, the normal operation
of the appliance will be affected.
H
OW TO REMOVE THE BOTTOM EQUIPMENT PROTECTION
1. To remove the bottom equipment protection (A), you must first tilt the appliance
backwards carefully. You need at least 2 people to do this (see fig. below).
Depending on model.
25
~ ~
90
25
, before you