LG MU2R15 Bedienungs- Und Montageanleitung Seite 6

SAFETY INSTRUCTIONS
6
• Ventilate the product room from time to time when operating it together with a stove, or
heating element etc. Oxygen deficiency can occur and hence harm your health.
• When the product is not to be used for a long time, disconnect the power
supply plug or turn off the breaker. There is risk of product damage or failure, or
unintended operation.
• Take care to ensure that nobody especially kids could step on or fall onto the
outdoor unit. This could result in personal injury and product damage.
• Take care to ensure that power cable could not be pulled out or damaged during
operation. There is risk of fire or electric shock.
• Do not place anything on the power cable. There is risk of fire or electric shock.
• When flammable gas leaks, turn off the gas and open a window for ventilation
before turning on the product. Do not use the telephone or turn switches on or
off. There is risk of explosion or fire.
• Make sure to ventilate sufficiently when this air conditioner and a heating
appliance such as a heater are used simultaneously. Failure to do so may result
in fire, serious injury, or product failure.
• Periodic ( more than once/year ) cleaning of the dust or salt particles stuck on
the heat exchanger by using water.
• Dismantling the unit, treatment of the refrigerant oil and eventual parts should
be done in accordance with local and national standards.
CAUTION
!
Installation
• Two or more people must lift and transport the product. Avoid personal injury.
• Do not install the product where it will be exposed to sea wind (salt spray)
directly. It may cause corrosion on the product.
• Install the drain hose to ensure that the condensed water is drained away
properly. A bad connection may cause water leakage.
• Keep level even when installing the product. To avoid vibration or noise.
• Do not install the product where the noise or hot air from the outdoor unit could
damage or disturb the neighborhoods. It may cause a problem for your
neighbors and hence dispute.
• Always check for gas (refrigerant) leakage after installation or repair of product.
Low refrigerant levels may cause failure of product.
• Any person who is involved with working on or breaking into a refrigerant circuit
should hold a current valid certificate from an industry-accredited assessment
authority, which authorizes their competence to handle refrigerants safely in
accordance with an industry recognized assessment specification.
• Wear adequate personal protection equipment (PPE) when installing,
maintaining or servicing the product.
• If the supply cord is damaged, it must be replaced by a special cord or assembly
available from the manufacturer of its service agent.