Quick Pre-Heating; Starting, Interrupting And Ending The Oven's Operation - hanseatic HBO7213A1 Gebrauchsanleitung

Page EN-14 Operating the oven
3. Tap the TEMP/TIME sensor.
The display on the right dial shows the cur-
rent setting:
4. Turn the right dial until the display on the
dial shows the required cooking time (1
minute up to 9 hours).
Please note: While setting, the display
changes from
Min:Sec
5. Tap the OK/START sensor to save the
setting.

Quick pre-heating

The oven offers this additional function in or-
der to speed up the pre-heating process (ex-
ceptions: functions ,
1. Select a function and set the temperature
and cooking time, as described above.
2. Tap the PREHEAT sensor.
3. The pre-heating symbol
pear in the display. The oven will begin to
heat. Once the pre-set temperature has
been reached, you will hear a signal tone.
• To stop pre-heating, tap the ON/OFF sensor.
to .
Hr:Min
).
will also ap-
Starting, interrupting and
ending the oven's operation
You have selected the function and set the
temperature and cooking time. In order to
• start/continue the operation, tap the OK/
START sensor.
The lighting will switch on; the oven will heat
up. During the heating process, the temper-
ature display illuminates. The red LEDs on
the outer edge of the dial show the heating
progress.
• pause operation, tap the PAUSE/CANCEL
sensor.
The indicator flashes to show that the oven
is no longer heating (up).
• To stop cooking, tap the PAUSE/CANCEL
sensor twice.
The oven is now in stand-by mode.
The function and temperature can be
changed at any point during the cooking
process. The change will take effect approx. 6
seconds after the last sensor operation.
Opening the oven door has no impact on the
oven's operation. The oven will continue to
heat.