Connecting The Device - Dometic POWER & CONTROL SMP439-11 Montage- Und Bedienungsanleitung

Installing the device
• Do not install the device
– In wet or damp environments
– In dusty environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
• The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces.
• The air inlet on both short sides of the device must remain clear.
• For ambient temperatures higher than 40 °C (such as in engine or heating com-
partments, or direct sunlight), the heat from the device under load can lead to
reduced output.
• The device must be installed on a level and sufficiently sturdy surface.
• When installing the device above batteries, ensure that the vent hoses are con-
nected tight and leak-proof to the batteries to avoid damage to the device
caused by escaping corrosive sulfur fumes.
A
NOTICE!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
5.2

Connecting the device

Connecting the battery
Observe the following instructions when connecting the battery:
!
CAUTION!
• Avoid coming into contact with the battery fluid.
• Batteries with a cell short circuit may not be charged, as explosive
gases may form due to overheating of the battery.
• Ensure that the battery terminals are clean when connecting them.
• Ensure that the plug connector is fitted securely.
• Select a connection cable with a sufficient cross-section (suitable for 15 A).
• Use both the positive and both the negative connections to connect the battery.
• Lay the cables in accordance with VDE 100 (Germany).
• Use the following cable colors:
– Red: positive connection
– Black: negative connection
12
SMP439-11 (7LA.915.681)
EN