Technical Data - Scheppach 5903819901 Original Bedienungsanleitung

d) Be particularly careful when working in the
area of the corners, sharp edges etc. Prevent
insert tools from bouncing against the work-
piece and getting caught. The rotating tool at-
tachment tends to jam at corners, sharp edges or
when it gets caught. This causes a loss of control
or kick-back.
e) Do not use the chainsaw blade to cut wood, a
segmented diamond cutting wheel with a seg-
ment gap over 10 mm or a toothed saw blade.
Such insert tools frequently cause kick-back and
loss of control.
Special safety instructions for polishing:
a) Do not allow any loose parts of the polish-
ing cover, especially fastening string. Stow
or shorten the fastening string. Loose, rotat-
ing fastening cords can catch your fingers or get
caught in the workpiece.
Special safety instructions for working with wire
brushes:
a) Note that the wire brush loses pieces of wire
even during normal use. Do not overtax the
wires by applying too much contact pressure.
Pieces of wire that fly off can easily penetrate thin
clothing and/or the skin.
b) If a protective cover is recommended, prevent
the protective cover and wire brushes from
touching. Disc and cup brushes can increase
their diameter due to contact pressure and centrif-
ugal forces.
Residual risks
The electric tool has been built according to state-
of-the-art and the recognised technical safety
rules. However, individual residual risks can arise
during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Important in-
formation" and the "Proper use" are observed along
with the whole of the operating instructions.
• Avoid accidental starting of the machine: the start
button may not be pressed when inserting the plug
in an outlet.
• Keep your hands away from the work area, when the
machine is in operation.
• Before performing setting or maintenance work, re-
lease the start button and pull out the power plug.

6. Technical data

Rated voltage
Rated input
Protection class
Idle speed n
Tool attachment Ø
Suction connection
Weight
Dimensions L x W x H
Technical changes reserved!
Noise/vibration information
m WARNING!
Working without hearing protection or protective cloth-
ing can result in damage to health.
• Wear hearing protection and appropriate protective
clothing when working.
Measured as per EN 62841-2-3 & EN 62841-1. The
noise at the work place can exceed 85 dB(A). In this
case, protective measures for the user are required
(wear suitable hearing protection).
Sound power level L
Sound pressure level L
Uncertainty K
The above mentioned values are device emissions
values and therefore do not necessarily represent safe
work place values. The correlation between emission
and exposure levels cannot reliably lead to a deriva-
tion of whether additional precautionary measures are
necessary or not.
Factors that could influence the respective emissions
level present at the work place include the specification
of the working area and the environment, the duration
of exposure, other noise sources and more.
Also pay attention to any possible deviations in the
national regulations for the reliable work place values.
However, the above mentioned information makes it
possible for the user to make a better assessment of
the dangers and risks.
www.scheppach.com
220 - 240 V~ / 50/60 Hz
o
ø 120 x 100 mm
460 x 205 x 140 mm
109 dB(A)
WA
98 dB(A)
pA
3 dB(A)
wa/pA
1300 W
II
900-3200 min
-1
ø 35 mm
4,6 kg
GB | 25