Disposal And Recycling; Troubleshooting - Scheppach 5903819901 Original Bedienungsanleitung

AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 square millimetres.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Connection type Y
If the mains connection cable of this device is dam-
aged, it must be replaced by the manufacturer, their
service department or a similarly qualified person to
avoid dangers.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Data of machine type plate

14. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle. The
device and its accessories are made of differ-
ent materials, such as metals and plastics.

15. Troubleshooting

Fault
Motor does not work
The engine runs slowly
and does not reach the
operating speed.
Motor makes excessive
noise
The motor does not reach
its full power.
Motor overheats easily.
Possible cause
Motor, cable or plug defective,
fuses burnt
Voltage too low, coils damaged,
capacitor burnt
Coils damaged, motor defective
Circuits in the network are over-
loaded (lamps, other motors, etc.)
Overloading of the motor, insuffi-
cient cooling of the motor
www.scheppach.com
Take defective components to special waste disposal
sites. Check with your specialist dealer or municipal
administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collec-
tion point for the recycling of old electrical and electron-
ic devices. Improper handling of waste equipment may
have negative consequences for the environment and
human health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natural re-
sources. You can obtain information on collection
points for waste equipment from your municipal admin-
istration, public waste disposal authority, an authorised
body for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Remedy
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger! Check
fuses and replace if necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by
a specialist
Arrange for inspection of the motor by a spe-
cialist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor, remove dust from
the motor in order to ensure optimal cooling of
the motor
GB | 29