After Deck - Zodiac NZO 760 Eignerhandbuch

INSTALLATION AND CIRCUITS – After deck
INSTALLATION OF THE AFTER DECK
The ship is delivered with an after deck that can be installed for the single engine
configuration.
- Align surface A of the after deck with surface B of the deck.
- Mark the position of the drill holes with a pen beneath the after deck.
- Drill 4 holes with a Ø4.2 bit over a length of 10 to 15 mm maximum.
- Apply Sikaflex on the after deck bearing surfaces.
- Reposition the after deck, tighten 4 self-tapping screws Ø4.8 X 19
- Clean off the excess Sikaflex
- Wait for 24 hours before climbing onto the after deck.
B
A
B