Teka AFF-Serie Bedienungsanleitung Seite 48

EN
Mode of
operation
This appliance can be used in extractor
mode or fi lter mode.
Extractor mode
The extracted air is purifi ed through the
grease fi lters and conveyed outside
via a
system of tubes.
Warning: The exhaust air must not
be conveyed into a functioning smoke
or exhaust gas fl ue or into an aeration
shaft which is used to ventilate rooms
in which heating appliances have been
installed.
■ If the exhaust air is to be conveyed
into a non-functioning smoke or
exhaust gas fl ue, authorisation must be
obtained from a specialist technician.
■ If the exhaust air is conveyed through
an external wall, a telescopic wall box
with non-return valve must be used.
Filter mode
The extracted air is purifi ed through
grease fi lters and an anti-odour fi lter
and can, therefore, be returned to
the kitchen.
Warning: To capture odours in
recirculation mode, a ceramic fi lter
needs to be installed.
The various installation options for the
appliance with recirculation mode are
indicated in the brochure and must be
requested from your specialist dealer.
The accessories needed are available
from specialist dealers, via customer
services and from the on-line store.
When installing an anti-odour fi lter,
the operating time control needs to
be activated in order to allow the fi lter
to be cleaned properly. This control is
activated by simultaneously pressing
the symbols and
during the fi rst minute after having
connected the hob to the power supply.
48
The display will read "on".
Note: If the appliance is repaired,
the runtime monitoring must be
activated again
Activating and
deactivating the extractor
function
Warnings
■ Always adjust the power to the
current conditions. In the event of
excessive steam, select a higher
extractor level.
■ If no metal grease fi lter is available,
the extractor mode cannot be switched
on. Insert the metal grease fi lter. The
hob functions are available without a
metal grease fi lter.
■ Do not block the extractor intake.
Do not place anything on the fi lter
cover. Otherwise the extractor power
will be reduced.
■ If a tall pot is used, optimum
extractor performance cannot be
guaranteed. Extractor performance
can be improved by placing a lid at
an angle on the pot.
Activating the extractor
function
The extractor system cannot be
switched on if the metal grease fi lter
has not been inserted properly. To
activate the extractor function, press
the symbol . The extractor function
starts at power level 0 and is shown
on the dedicated display.
Changing the extractor
power level
Slide the dedicated pointer and select
the desired power level (0-9). The set
power level is displayed.
Intensive level
In particular conditions, the intensive
extractor level can be activated.
To activate it, press and hold the
symbol for 2 seconds. The power
level indicated will display the symbol
P. The intensive extractor level will
last for a maximum of 6 minutes.
After this time, the extractor power will
automatically drop to level 9.
Deactivating the extractor
function
To switch the appliance off , press the
symbol .
To just switch the extractor function
off :
1. Press the dedicated pointer on the
symbol .
Note: depending on the settings
selected, the Delay function might
start after turning the appliance off .
Auto function
When selecting a level for a cooking
area, the automatic start of the
extractor module is activated.
Automatic start via the
cooking levels
The extractor function switches on at
a power level which depends on the
number of cooking areas activated.
Manual activation of the Auto
function
If the function has been deactivated
through the basic settings, the Auto
function can still be activated during
the normal use of the hob.
To activate this function, press the
symbol (26). To deactivate the
function, press the symbol
once more or change the extractor
power level using the dedicated
pointer.
Delay function
Thanks to this function, after switching
the hob off , the extractor system will
continue to operate for 15 minutes at
the current power level, removing any
steam still present in the kitchen. After
this time, it automatically switches off .
To activate the Delay function, press
(26)