Inflation System - Zodiac Futura MARK 2C Bedienungsanleitung

THE HIGH PRESSURE FOOT-PUMP
A
THE STANDARD VALVES
(1) cap (2) valve insert
To activate the standard valves into inflation
position:
• Free the valve insert from its protection.
• Unscrew the valve cap.
• Screw the valve insert onto its base (screw it tight
but without exaggeration, not to deteriorate the
screw thread) and check that the valve cap
remains accessible.
To deflate:
Unscrew the valve insert from its base
EASY PUSH VALVES
To activate the easy push valves:
To change position
Push
NOTE:

INFLATION SYSTEM

B
C
(3) base
In inflating position
The membrane is closed, the knob
NEVER TIGHTEN TOO MUCH: YOU COULD UNSCREW THE ENTIRE
INTERNAL INFLATION SYSTEM OF THE VALVE
6
Position A (CAP INSERTED)
The pump has maximum flow but low
pressure: this position is used to give
shape rapidly to all inflatable parts of
the boat.
Position B (WITHOUT CAP)
The flow is inferior to position A, but
provides pressure that is superior, with
the same effort.
Position C
To deflate. Insert the tube as indicated
in figure C and pump normally.
1
2
3
is up
/ 10
In deflating position
The membrane is open,
the knob is down