Problem
Entire spa is
EN
inoperative
The spotlight
inoperative
Pump motor will
not function
Pump motor runs,
but low or no
water/jet pressure
TROUBLESHOOTING
GENERAL OPERATION TROUBLESHOOTING GUIDE
Probable causes
• Power failure
• GFCI tripped
• Heater high limited thermostat
tripped
• The led is faulty
• Motor overload condition
• Dirty filter
• Clogged suction
Solutions
• Check power source
• Reset GFCI; call for service if it will not
reset
• Disconnect power for at least thirty
seconds to reset heater high limit. If it
will not reset, check for clogged filters. If
tripping continues, call for service
• Call for service
• Let cool for one hour. Motor overload
will reset automatically. If Problem
persists, contact your dealer
• start the washing / backwashing
procedure of the sand filter as described
on the dedicated manual
• Clean suction cover
36