Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PREPARING FOR USE CAUTION
The preliminary checks and any system adjustments must be performed by
qualified authorised Personnel (See the "ASSEMBLY MANUAL").
TURN ON the system's main switch.
FILLING THE SPA ONLY BY AUTOMATIC FILLING SYSTEM
In general, when the spa is filled for the first time, the water temperature is lower than the
set point set by the factory. For this reason, the circulation pump and heater are turned
on. (In any case the control panel will display the temperature of the water in the tub).
Before treating the water, proceed with the "FIRST START-UP" of the system (See
operation of the Display of the model installed in your spa).
OPERATION NOTE: Make sure you adjust your Total Alkalinity first, as an out-of-
balance condition will affect your ability to adjust the pH correctly, and will prevent
the sanitizer from operating effectively. The spa is ready for use when the spa
water has circulated and the chlorine level remains between 3 ppm and 5ppm.
CAUTION: if the spa has not been used for a long time, super chlorinate (shock
treatment) before using it again to disinfect the tub and the system.
Do not use the spa the FIRST TIME it is STARTED UP after super chlorination, given
the high concentration of disinfectants in the water at this time.
Completely drain the spa and refill.
SPA START-UP
11
EN
Werbung
Inhaltsverzeichnis
