glass 1989 Infinity Bedienungs- & Wartungsanleitung Seite 45

ROUTINE AND SPECIAL MAINTENANCE
- To clean the tub, use water at a temperature that does NOT exceed 60°C, to keep
its shine unaltered over time.
- Do not start the pump before the jets are completely covered by water.
- Do not obstruct the jets when the pump is operating.
- Always stop the pump before emptying the bath.
SAND FILTER MOVAL AND CLEANING INSTRUCTIONS
Turn off the power to the spa, then proceed as described on the dedicated manual:
JETS MAINTENANCE
If you notice that the jets spins slower than when the spa was new, or the jets are sticking,
the cause could be a build-up of deposits inside the jets. To remove the deposits, use
the following instructions:
1. With the spa off, rotate the jet face counter-clockwise until it stops.
2. Once the face stops rotating, use a little extra force to rotate the face even more
counter-clockwise past the locking position until it stops. Pull face with the body away
from the spa.
3. After flushing the bearing inside the body with water, spin the rotating eye, it should
spin very freely. If it does not, place the bearing end in a cup of vinegar (the vinegar
will soften any deposits). Leave soaking overnight. The next day, flush with water and
repeat the spin test.
NOTE: If it still doesn't spin freely than a second night of soaking is required. If the
jet still does not spin, you will have to purchase a new bearing from your dealer.
4. To replace, push the face body back into the spa fitting. Slighly rotate face body
in either direction until you feel the body align with the fitting, then press firmly on
the face body. Once seated, rotate the face clockwise using a little extra force to
overcome the locking position. If the face does not rotate, remove and rotate face
body 180°and repeat this step. Turn the pump on, the jet should spin freely.
CARE OF THE EXTERIOR
Stains and dirt generally will not adhere to your spa's surface. A soft rag should easily
remove most dirt. Stains and dirt generally will not adhere to your spa's surface. Most
household chemicals are harmful to your spa's shell. Cleaning of the surface should
only be done with a non-abrasive, non-sudsing cleaner. Always thoroughly rinse off
any spa shell cleaning agent with fresh water.
SERVICE NOTES:
1. Iron and copper in the water can stain the spa shell if allowed to go unchecked. Your
dealer can recommend a stain and scale inhibitor to use if your spa water has a high
concentration of dissolved minerals.
2. The use of alcohol or any household cleaners other than those listed to clean the spa
shell surface is NOT recommended. DO NOT use any cleaning products containing
WARNING
5
WARNING
EN