Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PARTS LIST (Continued)
FULL SIZE
REF.
GUN
30
-
31
-
32
-
33
-
34
-
35
-
The spray gun must be earthed to dissipate any electrostatic charges which may be created by fluid
or air flows. This can be achieved through the spray gun mounting, or conductive air/fluid hoses.
Electrical bond from the spray gun to earth should be checked and a resistance of less than 10⁶ Ohms
is required.
IMPORTANT: This spraygun is suitable for use with both waterbased and solvent based coating
materials.
The gun is not designed for use with highly corrosive and/or abrasive materials.
To avoid premature degradation of parts, DeVilbiss recommends the gun is washed in neutral
cleaning solution (pH 6 to 8).
The gun is not designed to be cleaned within an ultrasonic bath.
If there is any doubt regarding the suitability of a specific material, contact your DeVilbiss Distributor
or DeVilbiss direct.
SB-E-2-864 R1.1
PART No.
TOUCH-UP
GUN
-
AIR REGULATOR & GAUGE
-
FLUID NEEDLE
-
FLUID TIP
-
FILTER
-
CLEANING BRUSH.
-
SPANNER
DESCRIPTION
WARNING
CAUTION
8/12
EN
QTY.
1
1
1
1
1
1
www.carlisleft.com
Werbung
Inhaltsverzeichnis
