Carlisle DeVILBISS SLG-650 Bedienungsanleitung Seite 11

Depending on hose length, larger I.D. hose may be required. Install an air gauge at the gun handle.
When gun is triggered on, adjust regulated pressure as required. Do not use more pressure than is
necessary to atomise the material being applied. Excess pressure will create additional overspray and
reduce transfer efficiency.
If quick connect couplings are required, use only high flow quick connects. Other types will not flow
enough air for correct gun operation.
SPRAY GUN MAINTENANCE & CLEANING
To clean fluid passages, remove excess material, then flush with gun wash solution. Wipe the gun
exterior with a dampened cloth. Never completely immerse in any solvent or cleaning solutions as
this is detrimental to the lubricants and life of the spray gun.
To clean air cap and fluid tip, brush exterior with a stiff bristle brush. If necessary to clean cap holes,
use a broom straw or toothpick if possible. If a wire or hard instrument is used, extreme care must
be taken to prevent scratching or burring of the holes which will cause a distorted spray pattern.
SB-E-2-864 R1.1
NOTE
NOTE
11/12
EN
www.carlisleft.com