Securing The Frame Assembly; Mounting Main Barrel To The Cart; Securing Cart Panel To The Grill; Installing The Lid Handle - Pit Boss Navigator PB1230 Montageanleitung

6. SECURING THE FRAME ASSEMBLY

Parts Required:
1 x Cart Back Panel (#28)
1 x Cart Front Panel (#29)
Screw (#D)
8 x
Installation:
• Install Cart Back Panel to the front two Support Legs of the unit. Secure using
two screws on each side. Ensure the flat side of the Support Plate is facing
outwards. Repeat the same installation to Cart Front Panel plate to the other
Support Legs.

7. MOUNTING MAIN BARREL TO THE CART

Parts Required:
1 x Main Barrel (#11)
12 x Screw (#A)
12 x Washer (#B)
Locking Washer (#C)
12 x
Installation:
• Prepare the Main Barrel to be mounted to the Cart. Position the Cart next to
the Main Barrel, with both facing the same direction. Lock the Caster Wheels
on the Cart. Using a second person, prepare to lift the Main Barrel onto the
Cart. With one person lifting from the hopper side, and the other person
lifting from the opposing barrel end, carefully lift the Main Barrel, and slowly
lower onto the Cart.
• Next, open the Main Barrel lid. Adjust the rotation as needed to align the
screw holes of the Main Barrel to the Cart. Once placed, secure each leg to the
Main Barrel using three screws, washers, and locking washers.

8. SECURING CART PANEL TO THE GRILL

Parts Required:
Screw (#E)
4 x
Installation:
• Secure Cart Front / Back Panel to Barrel using four screws.

9. INSTALLING THE LID HANDLE

Parts Required:
2 x Lid Handle (#9)
Lid Handle Bezel (#10)
4 x
Installation:
• Remove the pre-installed screws from the Lid Handle. From inside the barrel
lid, insert one screw protrude to the outside. Add a Bezel on the screw. Then
hand-tighten the screw (from the inside) into the Lid Handle. Repeat for
other side.
6
28
29
7
11
8
E
E
E
E
9
9
10
A
C
B
9
10
7