Cutting Means Removal And Installation; Grass Catcher Cleaning And Replacement - Honda HRX537VKEA Bedienungsanleitung

CUTTING MEANS REMOVAL AND INSTALLATION

If you remove the cutting means for sharpening or replacement, you
will need a torque wrench for installation. Wear heavy gloves to
protect your hands.
Cutting means SHARPENING: To avoid weakening the cutting
means, or causing imbalance or poor cutting, the cutting means
should be sharpened by trained staff at an authorized Honda dealer.
Cutting means REPLACEMENT: Use Honda Genuine replacement
cutting means or their equivalent.
Removal
1. Turn the fuel valve OFF and disconnect the spark plug cap.
2. Tilt the mower to the right so the fuel cap is up. This will help to
prevent fuel leakage, motor oil seeping into the air filter, and hard
starting.
3. Use a 14 mm (6 point) socket wrench and remove the two
cutting-means bolts [1] and special washers [2] from the flywheel
brake assembly [5]. Use a wooden block to prevent the cutting
means from turning when removing the bolts.
[4]
[3]
[2]
[1]
4. Remove the upper [4] and lower cutting means [3].
Installation
1. Clean dirt and grass from around the cutting means mounting
area.
2. Install both cutting means [3] and [4] using the two cutting means
bolts [1] and special washers [2] as shown. Be sure to install the
special washers with the concave side toward the cutting means
and the convex side toward the head of the bolt.

Operating this mower with only one cutting means will
result in an improperly seated cutting means that can
be thrown from the mower and seriously hurt or kill
someone.
Always install both cutting means as a set.
The cutting-means bolts are specially designed for this application
and must not be replaced with other bolts.
[5]
WARNING
3. Tighten the cutting-means bolts with a torque wrench [7]. Use a
wooden block [6] to prevent the cutting means from turning.
[6]
[7]
Cutting-means bolt torque: 49 ~ 59 N·m
If you do not have a torque wrench, have an authorized Honda
dealer tighten the cutting-means bolts before you use the mower. If
the cutting-means bolts are overtightened, they could break. If the
cutting-means bolts are not tightened enough, they could loosen or
come out. In either case, it would be possible for the cutting means
to fly off while you are operating the mower.

GRASS CATCHER CLEANING AND REPLACEMENT

Cleaning
Wash the grass catcher with a garden hose, and allow it to dry
completely before use; a wet grass catcher will clog quickly.
Replacement
Replace a worn or damaged grass catcher with a Honda replacement
part or its equivalent.
Removal
1. Unclip the plastic edges [1]
of the grass catcher [2]
from the frame [3].
2. Remove the grass catcher
from the frame.
Installation
1. Insert the grass catcher frame [3]
into the grass catcher [2], as
shown above.
2. Clip the plastic edges [1] of the
grass catcher onto the frame.
OPERATION CHECK OF THE CUTTING-MEANS CONTROL
Start the engine outdoors. Release the cutting-means control lever;
the engine should stop quickly. If the engine does not stop quickly,
take the mower to an authorized Honda servicing dealer for repair.
ENGLISH
[3] [4]
[1]
[2]
[3]
[1]
[1]
[2]
15