Grass Catcher Cleaning And Replacement; Charging The Battery; Replacing A Fuse; Transporting - Honda HRX537C4HYEA Betriebsanleitung

3. Tighten the cutting-means bolts with a torque wrench [7]. Use a
wooden block [6] to prevent the cutting means from turning.
Cutting-means bolt torque: 49 ~ 59 N·m
If you do not have a torque wrench, have an authorized Honda
dealer tighten the cutting-means bolts before you use the mower. If
the cutting-means bolts are overtightened, they could break. If the
cutting-means bolts are not tightened enough, they could loosen or
come out. In either case, it would be possible for the cutting means
to fly off while you are operating the mower.

GRASS CATCHER CLEANING AND REPLACEMENT

Cleaning
Wash the catcher with a garden hose, and allow it to dry completely
before use; a wet catcher will clog quickly.
Replacement
Replace a worn or damaged catcher with a Honda replacement
catcher or its equivalent.
Removal
[2]
1. Unclip the plastic
edges [1] of the
catcher [2] from the
frame [3].
2. Remove the
catcher from the
[1]
frame.
Installation
1. Insert the catcher frame [3] into the
catcher [2], as shown above.
2. Clip the plastic edges [1] of the
catcher onto the frame.

CHARGING THE BATTERY

(HZEA TYPE)
The lawnmower engine has an internal charging system. Under
normal mowing usage it is not necessary to charge or maintain the
battery.
If the mower fails to start or has been stored for an extended period:
• Start the lawnmower using the recoil starter manually for one
mowing session. This should charge the battery sufficiently to use
the electric starter.
• If you prefer, there is an optional AC powered battery charger
available from your Honda dealer.
• If the lawnmower fails to start (after manually starting for one
mowing session) check for a blown fuse.
• If it still fails to start, take the lawnmower to an authorized Honda
servicing dealer.

REPLACING A FUSE

The electric starter circuit and battery are protected by a 30 amp fuse
[1] and 3 amp fuse [2]. If the 30 amp fuse burns out, the electric
starter will not operate and if the 3 amp fuse burns out, the battery will
not charge. The engine can be started manually if either fuse burns
out.
1. Remove the battery cover by removing the three cover mounting
screws [3].
2. Remove and inspect the fuses. If they are burned out, replace with
the correct fuse.
Never use a fuse with a rating other than shown. Serious damage
to the electrical system or a fire can result.
If a frequent fuse failure occurs, it usually indicates a short circuit or
an overload in the electrical system. Take the mower to an authorized
Honda servicing dealer for repair.

TRANSPORTING

[3]
Before Loading
If the engine has been running, allow it to cool for at least 15 minutes
before loading the mower on the transport vehicle. A hot engine and
exhaust system can burn you and can ignite some materials.
Turn the fuel valve to the OFF position. This will prevent carburetor
flooding and reduce the possibility of fuel leakage.
[1]
Handlebar Folding
1. Remove the grass
catcher. You can
place it on top of the
engine, with the
catcher opening to the
front.
2. Turn the handlebar
adjust knobs [1] 90°
into the unlock
position.
3. Fold handlebar [2]
over mower.
When folding the handlebar, be careful to avoid kinking or pinching
the control cables.
ENGLISH
[3]
[1]
[2]
OFF
[1]
[2]
17